Blackview S8 4G Phablet 10/19/2017Blackview S8 4G Phablet 5.7 inch Android 7.0 MTK6750V 1.5GHz Octa Core 4GB RAM 64GB ROM 8.0MP + 0.3MP Dual Front Cameras Touch Sensor
● Display: 5.7 inch, 1440 x 720 Pixel screen
● CPU: MTK6750V 1.5GHz Octa Core
● System: Android 7.0
● RAM + ROM: 4GB RAM + 64GB ROM
● Camera: 8.0MP ( SW 13.0MP ) + 0.3MP front cameras + 13.0MP + 0.3MP back cameras
● Sensor: Ambient Light Sensor, Gravity Sensor, Proximity Sensor
● SIM Card: dual SIM dual standby. 1 Micro SIM card + 1 Nano SIM card
● Feature: GPS
● Bluetooth: 4.0
2G: GSM 850/900/1800/1900MHz
3G: WCDMA 900/2100MHz
4G: FDD-LTE 800/900/1800/2100/2600MHz Check it here.
I changed the 'disable unused GPIO pins' option to 'on' in BIOS
and I do not remember it, but I think I changed 'stats after g3' to s0 and I saved it
after, it did not turn on. Backlight and screen did not come in
my tablet always booted when I connected power trough otg hub. but it didn't turn on like before
So I tried to disassemble and unplug the BIOS battery, but it did not have a bios battery and there was a chip called '25Q64FWIM'(I searched it it was EEPROM)
I thought I should reset it
I connected 8pin to each other and tried to boot but it didn't boot. However, when I disassemble it, I noticed that when the battery is repluged, the CPU is in a cold state. When I press the power button, the CPU became hot(seems like turned on but no screen). Can you tell what the symptoms are and how to fix them?
before doing that I'd cleared all partition of internal rom and installed win 10 on there ((haha, installing driver was very difficult, if you want some help, tell me)
I have Onda V919 air Dual OS but it's stuck in bootloop. I've tried to fix it by flashing the firmware but I'm unable to do so.
Maybe I don't have the correct firmware, I took it from XDA because I can't find it in download section of this forum.
Check attached files to see a picture of the back of my tablet and the error I'm getting when flashing.
Thank you for your help,
I have the Onda V919CH (windows 10 only.)
Is it possible to flash this, so I can use Android? If so, how would I go about this? I know it wouldn't be easy to do... but wanted to see
Hy forum, I just had idea for installing new Remix 3.0.... PC Version
Can it be possible to replace Windows 10 with this OS, So we can have Stock Android on one partition and Remix OS on other?.. Or maybe just installing Remix OS as a single OS?
Windows 10 is flashed using WINPE file, how could we flash Remix? Regular installation with pen drive or is there no way to do this?
If this theory comes true, we could install Remix OS on any Onda device that supports Windows.. Thank you for your attention, I hope we can do something about that idea
Link for Remix OS PC : http://www.jide.com/remixos-for-pc#downloadNow
By Bane R
Can you please post speeds that you get from MicroSD cards on V80 Plus tablet? I am getting 11-12 MB/s (both write and read) no matter how fast MicroSD card is. I understand that I cannot get full speed of very fast cards, but is there a way to get little bit more speed out of It?